This 304 stainless steel ball valve has 1/2" FNPT on both ends and is built in two main pieces. The valve can be taken apart just by loosening the large TC clamp in the center. You will gain access to the seals, ball and main valve cavity for fast cleaning which is key for any cold size operation or fermenter. These would be considered FULL FLOW valves since the bore in the ball is over 1/2"

VERY IMPORTANT NOTE. Though this valve comes apart by hand via a central TC clamp, by design it is still a ball valve that seals due to being squeezed between two PTFE seats. These seats get "lapped in" to a particular valve. When you take this valve apart for cleaning, you must either leave the PTFE seats in place or keep each of their install locations straight. That is, do not swap the positions of the seats. It is even more important not to swap seats between different valves. If you do swap positions or valves, you are likely to encounter slow leaks or at the very least have to crank down on the central TC valve much harder.