Return to Install Tool for 1/2" NPT Pull Through Bulkheads

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 2

0 of 0 people found the following review helpful:

these made my kettle build easy December 6, 2020 Reviewer: Brad from COVINGTON, WA United States   I used these with the 1.5 TC radius flanges to build my kettles.  Made it an easy job.  Watch Bobby's videos and follow the instructions.  If you're not sure if it's clean enough, it's not.  ask how I know. It's harder to clean after most of the solder has bonded, but can be fixed. Thanks BrewHardware! Was this review helpful to you?

0 of 0 people found the following review helpful:

Easy to use May 20, 2019 Reviewer: David Gunnell from Blue Ridge, GA United States   Just used this tool to add three solderable bulkheads on couple of kettles.  Very easy to use just follow videos. Was this review helpful to you?

0 of 0 people found the following review helpful:

March 18, 2019 Reviewer: John from Audubon, NJ United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

March 5, 2019 Reviewer: Terrance Nallenweg from Westville, IN United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

April 9, 2018 Reviewer: John Neece from Sandpoint, ID United States   Easy to use and fun .Thanks Bobby! Was this review helpful to you?

0 of 0 people found the following review helpful:

Tool for 1/2" NPT Pull Through Bulkheads March 15, 2018 Reviewer: jeff hofstra from rochester, NY United States   This is such a great idea. I have not had a chance to use it. I've watched Bobby's how to video and hopefully I'll be able to try it very soon Was this review helpful to you?

0 of 0 people found the following review helpful:

Brilliant, wouldn't use anything else again!! November 19, 2017 Reviewer: Damian Scott from Perth, Western Australia Australia   Was this review helpful to you?

0 of 0 people found the following review helpful:

Worked great! October 5, 2017 Reviewer: Donald Ayer from Wilmington, MA United States   In retrospect, I feel like I could have pieced this together with bits around my shop, but it wasn't it certainly wasn't overly pricey and it works perfectly. Was this review helpful to you?

0 of 0 people found the following review helpful:

Worked perfectly July 3, 2017 Reviewer: Brandon White from Dripping Springs, TX United States   Pulled fitting through a 1+mm pot with a 21mm hole with minimal effort. The cost is very good too compared to trying to source all of the parts yourself. Was this review helpful to you?

0 of 0 people found the following review helpful:

Tool worked February 8, 2016 Reviewer: Russ Malinowski from Franklinville, NY United States   The install tool worked, but the thread length on the bolt is too short to use as is.  I solved by adding a piece of copper tubing between the washer and bushing on the small end.  I realize how hard it is to find a bolt with more threads, so maybe including some sort of spacer would help.  Overall, the tool worked well, I only had to use two adjustable wrenches. Was this review helpful to you?