Return to Step Bit, Small 1/8" - 7/8" in 1/16" increments
Sort By::
Page of 1


  0 of 0 people found the following review helpful:
 
5 of 5 September 26, 2024
Reviewer: Jason Sharp from Silverthorne, CO United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 A Must Have. Right Tool For The Job December 21, 2021
Reviewer: The Mot Brewer from FRANKLIN, TN United States  
Bobby at brewhardware, understands the hobby. He goes to the trouble and makes tools that you need available to you. This is worth every penny., You can be confident they have been tested for your application.

This drill bit worked very well for to let me drill a hole on my kettle for the spin cycle.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 July 26, 2020
Reviewer: William Haumann from Hamilton , NJ United States  
Good value, worked just fine. My drill was a bit lacking in torque, so I did finish up with a hand brace and the bit worked well that way too.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
4 of 5 February 15, 2018
Reviewer: Dick Parker from Stilwell, KS United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 1/16" increments are key! July 9, 2016
Reviewer: Andrew Tucker from Waterford, MI United States  
I had a step bit that only had 1/8" increments (and cost three times as much as this one) and wanted to install a couple of the true weldless bulkhead fittings with the o-ring gaskets. Those require a 13/16" hole, so I ordered this along with. Cuts quickly and held up great.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
4 of 5 Great June 12, 2016
Reviewer: Mike Maskewicz from Willow Spring, NC United States  
This drove it here cut through stainless steel like butter. Very good products for the price

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 convenient January 7, 2015
Reviewer: Warren Jewell from Estero, FL United States  
not only can you get the fittings, but you can get the tools needed to install them.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 work horse December 9, 2014
Reviewer: amando cardenas from Escondido, CA United States  
We had no problem getting through my SS kettle with this Bit, And it will drill a few more wholes without a doubt

Was this review helpful to you?