Return to SS Washer for 1/2 NPT, bulkheads, etc THICK 1/8"
Sort By::
Page of 1


  0 of 0 people found the following review helpful:
 
5 of 5 January 19, 2021
Reviewer: JAMES KEMPINSKI from Bethel Park, PA United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Good stuff May 8, 2017
Reviewer: Jerry Olstad from Fort Bragg, CA United States  
I have bought a lot of fittings and Camlock parts from these guys everything is top notch and functions as it should.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
4 of 5 Great hardware October 20, 2016
Reviewer: Ryan Johnson from Aliso Viejo, CA United States  
These have a slightly smaller ID than the 1/16 washers so they don't slide all the way onto male NPT threads.  Otherwise great for adjusting for varying bulkhead thicknesses.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Worked great September 16, 2016
Reviewer: Ralph B from Sewickley., PA United States  
Just the right size for sealing my ball valve to my mash tun.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Quality washers April 28, 2016
Reviewer: Justin Heisler from Charlottesville, IN United States  
Great fit, does what it's supposed to.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Great for bulkhead builds March 31, 2016
Reviewer: John Anderson from Pasadena, TX United States  
Had to build a few irregular bulkheads when installing a recir. loop in my HLT and these fit the bill. They seal up everything just fine.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Its a washer! July 25, 2015
Reviewer: Steven Offutt from Ridgecrest, CA United States  
As advertised. Works great for cooler mlt.

Was this review helpful to you?