Return to Ball Valve, 1/4" NPT to 1/4" MFL with Check
Sort By::
Page of 1


  0 of 0 people found the following review helpful:
 
5 of 5 May 3, 2023
Reviewer: Jacob Schray from Wind Gap, PA United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Good insurance April 22, 2022
Reviewer: Janet Piez from New York, NY United States  
These ball valves added to a distributer are good insurance against an unused DQ leaking from the poppet. In the unlikely event that you attempt to put a liquid DQ onto the gas post (not that I would do such a thing),  the valve would prevent the mess from getting completely out of hand. Good products plus the usual amazing customer service equals a happy customer!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 REBBREWER May 31, 2020
Reviewer: TED from IRONDEQUOIT, NY United States  
The 1/4'' ball valve I ordered from BrewHardware, works very good on my taprite CO2 regulators.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
5 of 5 Added to the regulator January 19, 2020
Reviewer: Edward Gierlach from Dacula, GA United States  
Upgrading my gas lines to the 4mm ID EVA Lines, and I needed a new valve from my regulator. This part plus a push fit fitting Does exactly that. (I used some yellow Teflon on the NPT out of habit) No leaks, perfect fit.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 November 30, 2019
Reviewer: JOHN DUNLOP from LANDRUM, SC United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Quality Product June 10, 2019
Reviewer: Maxwell Karpov from State College, PA United States  
Quality valve.  Works as intended.
The flow is FROM the 1/4" NPT through the valve, out the flare.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
5 of 5 good ball valves September 4, 2017
Reviewer: Michael Harper from Austin, TX United States  
I used these to replace the barbed ones on a regulator as I'm using flares throughout. These work perfectly and have a check valve also.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Perfect May 15, 2017
Reviewer: Andrew Armstrong from Fort Bragg, CA United States  
I love flared connections and brewhardware.com has the best ones I have ever used.

Was this review helpful to you?